Search Results

Reduction of the amount of platinum group metals (PGM: Pt, Pd, Rh) utilized in three-way catalysts (TWC) has been required from a point of resource shortage and cost effectiveness. A conventional TWC system is composed of a close-coupled (CC) catalyst and an underfloor (UF) catalyst, both PGM-based. The CC-TWC promotes HC/CO oxidation and NOx reduction by CO. The UF-TWC mainly facilitates further NOx reduction by CO. In this study, a TWC system comprising a CC catalyst with PGM and an UF catalyst without PGM has been described. The newly developed system, performing reasonably well with a conventional stoichiometric gasoline combustion engine, offers an opportunity to reduce PGM usage. In this system, the UF-non-PGM catalyst is composed of a Ni/CeO2 bottom layer which functions as a deNOx catalyst with CO-NO reaction and a zeolite based top layer which works as a deNOx catalyst with passive NH3-SCR reaction.

For diesel emission control systems containing a Diesel Oxidation Catalyst (DOC) and a Catalyzed Soot Filter (CSF) the DOC is used to oxidize the additional fuel injected into the cylinder and/or the exhaust pipe for the purpose of increasing the CSF inlet temperature during the soot regeneration. Hydrocarbon (HC) oxidation performance of the DOC is affected by HC species as well as a catalyst design, i.e., precious metal species, support materials and additives. How engine-out HC species vary as a function of fuel supply conditions is not well understood. In addition, the relationship between catalyst design and oxidation activity of different hydrocarbon species requires further study. In this study, diesel fuel was supplied by in-cylinder, post injection and exhaust HC species were measured by a gas chromatograph-mass spectrometry (GC-MS) and a gas analyzer. The post injection timing was set to either 73°, 88° or 98° ATDC(after top dead center).

To meet the severe PM (Particulate Matter) emission regulation for diesel vehicles, use of a DOC (Diesel Oxidation Catalyst) + CSF (Catalyzed Soot Filter) emission control system has recently been started in Japan. The CSF is used for diesel exhaust soot filtering, and the accumulated soot is periodically combusted to regenerate the CSF. The heat required for the soot regeneration is supplied from the DOC pre-cat under a specific regeneration mode. Additional fuel is supplied to the DOC by post injection and/or fuel dosing into the exhaust pipe upstream of DOC. The resulting exotherm provides the heat for soot combustion on the CSF. Uniform and controlled soot combustion in the CSF is necessary to maintain system durability during the vehicle's life. There are concerns that non-uniform fuel supply to the DOC front face may lead to non-uniform soot combustion in the CSF.

Combustion behavior of the SOF (Soluble organic fraction) fraction of diesel particulate by flow-thru type diesel oxidation catalysts (DOC) was studied. A two brick DOC system with an air gap showed higher SOF performance than a single brick DOC of the same total volume. Collision frequency of the TPM (total particulate matter) to the catalyst layer was studied by calculation of the turbulence energy in the gas flow channel. No large difference in collision frequency was observed between one brick and two bricks. The front face effect was calculated from the geometric surface and it was confirmed that such an effect was small in the two brick DOC case. The SOF performance advantage for the two brick DOC system separated by an air gap was due to a thermo-mass effect created by reducing the DOC volume.