Search Results

Seatback strength and injury potential in moderate to high-speed rear-end collisions were investigated in a series of 12 HYGE sled tests. The test methodology included the use of instrumented Hybrid-III anthropomorphic test devices (ATDs). Four tests employed a 95th percentile male ATD ballasted to a total weight of 300 lbs and subjected to approximate 15 mph Delta-V impacts. The remaining tests employed an unmodified 50th percentile male ATD with impacts of approximately 25 mph Delta-V, and three ATD positions, including two "out of position" postures corresponding to leaning forward ("forward" position), and leaning forward and inboard ("radio" position). Seats from three different vehicles were tested, representing a range of strength values. Upper neck values for N were less than 1.0 in all cases. Lower neck N values sometimes exceeded 1.0 with the 50th percentile male ATD out of position, and these values did not trend with seatback strength.

Previous studies have suggested injury assessment reference values (IARVs) for lower neck injury based on scaled upper neck values. This study developed independent flexion and extension IARVs for the lower neck by matching Anthropomorphic Test Device (ATD) data to impact-tested post-mortem human subjects (PMHSs) with mid- to low-cervical spine injuries. Pendulum and sled tests with Hybrid III midsize male and small female ATDs were run under conditions mimicking those of published PMHS torso drop-sled tests and other PMHS studies. Measurements included upper and lower neck forces and moments, head acceleration, head rotation rate, and head/neck angles for the pendulum tests. Rear impacts corresponding to rigid seatback tests without a head restraint produced lower neck extension moments that increased dramatically with test severity, as measured by increasing delta-V and/or decreasing pulse duration.

The potential for injury to the acromioclavicular (AC) and coracoclavicluar (CC) ligaments as potential sequelae of rear-end collisions is examined. In the current study, rear-end impact data from four crash tests were analyzed to quantify and bound forces applied to the shoulder of the Hybrid III 50th percentile male occupant seated in the target vehicle. Two potential scenarios for AC and CC ligament loading were examined: 1) relative motion between the clavicle and shoulder due to belt loading on the shoulder and torso, and 2) compression of the humerus into the glenoid fossa due to locked arms on the steering wheel. Assumptions were made for the shoulder load calculations to obtain a conservative upper bound of loads that could be applied to the AC and CC ligaments. With the target vehicle at rest, the bullet vehicle speeds were 5, 10, 15, and 20 mph, yielding target vehicle changes in velocity (delta-V) of 3.9, 6.5, 8.9 and 12.2 mph.

High speed craft are used by civilian agencies and the military for rescue, for interdiction, and for rapid insertion and extraction of forces. Ensign et al. (2000) found evidence of a significant injury problem in a study of self-reported injuries of boat operators of high speed craft. Though repeated vertical spinal impacts with greater than 10 g peak accelerations may occur in such craft, there is currently no completely suitable injury criterion to predict the likelihood of spinal injuries from high speed craft operations. A new low-order dynamics metamodel for predicting vertical impact to the human spine has been developed using a Madymo (TNO, Inc) simulation of a seated occupant under predominantly vertical impact. This model has been validated using experimental high speed craft operations for impacts with vertical accelerations greater than 10 g.