Search Results

Owing to the presence of oxygen atoms in biodiesel, the use of this fuel in compression ignition (CI) engines has the advantage of reducing engine-out harmful emissions. In this context, biodiesel fuel can also be used to extend the low temperature combustion (LTC) regime because it inherently suppresses soot formation within the combustion chamber. Therefore, in this study, LTC characteristics of biodiesel were investigated in a single cylinder CI engine; the engine performance and emission characteristics with biodiesel and conventional petro-diesel fuels were evaluated and compared. A modulated kinetics (MK)-like approach was employed to realize LTC operation. The engine test results showed that LTC operation was achieved by retardation of the fuel injection timing. The results also showed that using biodiesel reduced smoke, THC, and CO emissions but increased NOx emissions.

Previous studies of gasoline direct-injection compression-ignition (GDCI) showed good potential for very high efficiency, low NOx, and low PM over the full speed-load range. Low-temperature combustion was achieved using multiple-late injection (MLI), intake boost, and cooled EGR. Advanced injection and valvetrain were key enablers. In the current study, a new piston was developed and matched with the injection system. Single-cylinder engine tests were conducted with the objective to reduce injection pressure, intake boost, and swirl levels. Results showed that ISFC could be further improved while maintaining low levels of NOx, PM, and combustion noise. Efficiency loss analysis indicated a very efficient thermodynamic process with greatly reduced heat losses. Injection parameters could be used to control combustion phasing with good combustion stability. Engine simulations were performed to develop a practical boost system for GDCI.

The goal of this research is to investigate the physical parameters of stoichiometric operation of a diesel engine under a light load operating condition (6∼7 bar IMEP). This paper focuses on improving the fuel efficiency of stoichiometric operation, for which a fuel consumption penalty relative to standard diesel combustion was found to be 7% from a previous study. The objective is to keep NOx and soot emissions at reasonable levels such that a 3-way catalyst and DPF can be used in an aftertreatment combination to meet 2010 emissions regulation. The effects of intake conditions and the use of group-hole injector nozzles (GHN) on fuel consumption of stoichiometric diesel operation were investigated. Throttled intake conditions exhibited about a 30% fuel penalty compared to the best fuel economy case of high boost/EGR intake conditions. The higher CO emissions of throttled intake cases lead to the poor fuel economy.