Search Results

This work presents a study to characterize and quantify the mechanical losses in small automotive turbocharging systems. An experimental methodology to obtain the losses in the power transmission between the turbine and the compressor is presented. The experimental methodology is used during a measurement campaign of three different automotive turbochargers for petrol and diesel engines with displacements ranging from 1.2 l to 2.0 l and the results are presented. With this experimental data, a fast computational model is fitted and used to predict the behaviour of mechanical losses during stationary and pulsating flow conditions, showing good agreement with the experimental results. During pulsating flow conditions, the delay between compressor and turbine makes the mechanical efficiency fluctuate. These fluctuations are shown to be critical in order to predict the turbocharger behaviour.

Nowadays turbocharging the internal combustion engine has become a key point in both the reduction of pollutant emissions and the improvement of engine performance. The matching between turbocharger and engine is difficult; some of the reasons are the highly unsteady flow and the variety of diabatic and off-design conditions the turbocharger works with. In present paper the importance of the heat transfer phenomena inside small automotive turbochargers will be analyzed. These phenomena will be studied from the point of view of internal heat transfer between turbine and compressor and with a one-dimensional approach. A series of tests in a gas stand, with steady and pulsating hot flow in the turbine side, will be modeled to show the good agreement in turbocharger enthalpies prediction. The goodness of the model will be also shown predicting turbine and compressor outlet temperatures.

Fuel consumption in internal combustion engines and their associated CO2 emissions have become one of the major issues facing car manufacturers everyday for various reasons: the Kyoto protocol, the upcoming European regulation concerning CO2 emissions requiring emissions of less than 130g CO2/km before 2012, and customer demand. One of the most efficient solutions to reduce fuel consumption is to downsize the engine and increase its specific power and torque by using turbochargers. The engine and the turbocharger have to be chosen carefully and be finely tuned. It is essential to understand and characterise the turbocharger's behaviour precisely and on its whole operating range, especially at low engine speeds. The characteristics at low speed are not provided by manufacturers of turbochargers because compressor maps cannot be achieve on usual test bench.

This paper presents a prospective combustion study about dilution effects on turbocharged SI engine at full load. It proposes a comparative analysis between lean burn and cooled exhaust gas recirculation (EGR) operation as knock improvement artifice in substitute of enrichment. The study was led on a four cylinder 2L engine on stationary test bench. A specific EGR circuit was designed in order to achieve high control of the temperature and mass flow of the recirculated gas. Thanks to instantaneous pressure cylinder transducers, a combustion analysis was carried out using an home-made code. 1-D simulations (WAVE code) were used to complete the analysis on volumetric efficiency and turbocharger behaviour. A real advantage of cooled EGR was observed in the study compared to lean burn or enrichment in terms of performance, heat exchange and specific fuel consumption.