Search Results

This paper presents a novel 6-DOF multi-physics model of a cab suspension system. The model consists of a cab with six degrees of freedom supported by four fluid filled viscous mounts. In the literature, to the best of the authors' knowledge, all 6-DOF cab models have simplified fluid filled mounts as spring damper combinations. In its best case, a nonlinear stiffness relationship is allowed in the simplified models to capture the nonlinear behavior of the mounts and include geometric constraints and hard-stops. The novel model presented in this paper, however, includes a multi-physics model of the mounts. Each mount is represented by a molded assembly, two fluid chambers, a fluid track that connects the two chambers, and a gas chamber. Each mount can be pressurized or vented. A simple cavitation model is also used as an indicator of fluid cavitation in each mount.

This work pertains to laboratory testing of truck cab suspensions for the purpose of improving in-cab ride quality. It describes the testing procedure of a complete truck cab suspension while still being mounted on the vehicle. It allows for testing with minimal amount of resources, limited to two mobile actuators and minimal modifications to the stock vehicle. The actuators can be attached to any axle through a set of modified brake drums and excite the drive axle in a vertical plane. The excitation signal sent to the actuators can be in phase for a heave type motion or out of phase for a roll motion. The chassis shock absorbers are replaced with rigid links to prevent the actuator input from becoming filtered by the primary suspension. This allows the input to reach the cab suspension more directly and the cab to be excited across a broader range of frequencies.

This study pertains to motion control algorithms using statistical calculations based on relative displacement measurements, in particular where the rattle space is strictly limited by fixed end-stops and a load leveling system that allows for roll to go undetected by the sensors. One such application is the cab suspension of semi trucks that use widely-spaced springs and dampers and a load leveling system that is placed between the suspensions, near the center line of the cab. In such systems it is possible for the suspension on the two sides of the vehicle to settle at different ride heights due to uneven loading or the crown of the road. This paper will compare the use of two moving average signals (one positive and one negative) to the use of one root mean square (RMS) signal, all calculated based on the relative displacement measurement.