Search Results

Occupant kinematics during rollover motor vehicle collisions have been investigated over the past thirty years utilizing Anthropomorphic Test Devices (ATDs) in various test methodologies such as dolly rollover tests, CRIS testing, spin-fixture testing, and ramp-induced rollovers. Recent testing has utilized steer maneuver-induced furrow tripped rollovers to gain further understanding of vehicle kinematics, including the vehicle's pre-trip motion. The current study consisted of two rollover tests utilizing instrumented test vehicles and instrumented ATDs to investigate occupant kinematics and injury response throughout the entire rollover sequences, from pre-trip vehicle motion to the position of rest. The two steer maneuver-induced furrow tripped rollover tests utilized a mid-sized 4-door sedan and a full-sized crew-cab pickup truck. The pickup truck was equipped with seatbelt pretensioners and rollover-activated side curtain airbags (RSCAs).

It is well known from field accident studies and crash testing that seatbelts provide considerable benefit to occupants in rollover crashes; however, a small fraction of belted occupants still sustain serious and severe neck injuries. The mechanism of these neck injuries is generated by torso augmentation (diving), where the head becomes constrained while the torso continues to move toward the constrained head causing injurious compressive neck loading. This type of neck loading can occur in belted occupants when the head is in contact with, or in close proximity to, the roof interior when the inverted vehicle impacts the ground. Consequently, understanding the nature and extent of head excursion has long been an objective of researchers studying the behavior of occupants in rollovers.

Recently, side-by-side Recreational Off-Highway Vehicles (ROVs) have brought elements of the on-road vehicle occupant environment to the off-road trail-riding world. In general, ROV occupant protection during normal operation and in accident scenarios is provided predominately by a roll cage, seatbelts, contoured seats with seat backs, handholds, and other components. Typical occupant responses include both passive (inertial) and active (muscular) components. The objective of the current study was to evaluate and quantify these passive and active occupant responses during belted operation of an ROV on a closed course, as well as during 90-degree tip-over events. Passive occupant responses were evaluated using anthropomorphic test devices (ATDs) in 90-degree tip-overs simulated on a deceleration sled.

Rollover events involving multiple revolutions are dynamic, high-energy, chaotic events that may result in occupant injury. As such, there is ongoing discussion regarding methods that may reduce injury potential during rollovers. It has been suggested that increasing a vehicle's roof strength will mitigate injury potential. However, numerous experimental studies and published field accident data analyses have failed to show a causal relationship between roof deformation and occupant injury. The current study examines occupant kinematics and injury mechanisms during dolly rollover testing of a vehicle with a high roof strength-to-weight ratio (SWR = 4.8). String potentiometers and high-speed video cameras were used to capture and quantify the dynamic roof motion throughout the rollover. Instrumented Anthropomorphic Test Devices (ATDs) in the front occupant positions allowed for the assessment of occupant kinematics, loading, and injury mechanics during the rollover event.

Properly restraining a child in an automotive seat may require the use of a weight- and size-appropriate Child Restraint System (CRS). Proper installation of the CRS is a critical part of protecting a child during a motor vehicle collision. During a collision, child occupants sometimes exert enough force on the restraint system to generate load marks on the CRS and the vehicle restraint system. These marks are often relied upon by investigators to determine if the child occupant was properly restrained at the time of the collision. This paper is an observational study of the load marks generated from sled testing that was conducted using Hybrid III 3-year-old and 6-year-old Anthropomorphic Test Devices (ATDs). Tests were conducted with various child restraint systems that were installed in accordance with the manufacturer's recommendations as well as installed improperly. Additional tests were conducted with the ATDs without the use of a CRS.

Vehicle occupants undergo upward and outward excursion during the airborne phase of vehicle rollover due to the inertial effects coming from the vehicle's rotation. When this excursion is sufficient to permit contact between the occupant's head and the vehicle's interior roof panel, the neck may experience compressive loading. This compressive loading, generated during the airborne phase and prior to vehicle-to-ground impact, could render the occupant more susceptible to compressive neck injury during subsequent vehicle-to-ground impacts. In the present study, computational simulations were used to evaluate the effect of steady-state roll rate on compressive preloading in the cervical spine. The results show an increasing relationship between roll rate and compressive preloading when the head contacts the roof panel and becomes constrained.

There is a paucity of data regarding the potential for pediatric cervical spine injury as a result of acceleration of the head with no direct impact during automotive crashes. Sled tests were conducted using a 3-year-old anthropomorphic test device (ATD) to investigate the effect of restraint type and crash severity on the risk of pediatric inertial neck injury. At higher crash severities, the ATD restrained by only the vehicle three-point restraints sustained higher peak neck tension, peak neck extension and flexion moments, neck injury criterion (Nij) values, peak head accelerations, and HIC values compared to using a forward-facing child restraint system (CRS). The injury assessment reference values (IARVs) for peak tension and Nij were exceeded in all 48 and 64 kph delta-V tests using any restraint type.

The results of a number of previous studies have demonstrated that seat-belted occupants can undergo significant upward and outward excursion during the airborne phase of vehicular rollover, which may place the occupant at risk for injury during subsequent ground contacts. Furthermore, testing using human volunteers, ATDs, and cadavers has shown that increasing tension in the restraint system prior to a rollover event may be of value for reducing occupant displacement. On this basis, it may be argued that pretensioning the restraint system, utilizing technology developed and installed primarily for improving injury outcome in frontal impacts, may modify restrained occupant injury potential during rollover accidents. However, the capacity of current pretensioner designs to positively impact the motion of a restrained occupant during rollover remains unclear.

Anthropomorphic test dummies (ATDs) have been validated for the analysis of various types of automobile collisions through pendulum, impact, and sled testing. However, analysis of the fidelity of ATDs in rollover collisions has focused primarily on the behavior of the ATD head and neck in axial compression. Only limited work has been performed to evaluate the behavior of different surrogate models for the analysis of occupant motion during rollover. Recently, Moffatt et al. examined head excursions for near- and far-side occupants using a laboratory-based rollover fixture, which rotated the vehicle about a fixed, longitudinal axis. The responses of both Hybrid III ATD and human volunteers were measured. These experimental datasets were used in the present study to evaluate MADYMO ATD and human facet computational models of occupant motion during the airborne phase of rollover.

While previous studies have recognized and demonstrated the upward and outward occupant motion that occurs during the airborne phase of rollover and estimated the resulting head excursion using static and dynamic approaches, the effect of roll rate on restrained occupant head excursion has not been comprehensively evaluated. Moffatt and colleagues recently examined head excursions for near- and far-side occupants resulting from steady-state roll velocities using a laboratory fixture and both Hybrid III anthropomorphic test dummies (ATD) and human volunteers. To expand upon that study, a MADYMO computational model of a rolling airborne vehicle was developed to more thoroughly evaluate the effects of roll rate on occupant kinematics and head excursion. The interior structure of the vehicle used by Moffatt et al. was modeled, and the ATD kinematics observed in that experimental study were used to validate the computational models of the current study.

A MADYMO simulation model was created to analyze the kinematics of a bicycle rider during a frontal collision with a rigid object. The model was validated using a series of crash tests in which rider trajectory was captured with high-speed photography. The test bicycles were equipped with either traditional fixed or suspension front forks. Impact speeds varied from 22.5 to 31.0 kph to cover a range of fork response from minor bending to significant bending and fracture. The predictions of simple particle trajectory analysis were found to approximate rider motion. Rider motion was relatively unaffected by hand and foot “connections” to the bicycle. Furthermore, the rider connection to the bicycle was insufficient to create any significant rider deceleration as a result of bicycle fork deformation.