Search Results

In the present work, an automotive Diesel engine has been experimentally tested under a New European Driving Cycle (NEDC) with the aim of getting experimental plots of time dependent partitioning of energy injected during the warm-up process. An additional objective of this work is to assess the energy recovery capacity installed in the engine, i.e., to assess how much of the energy that leaves the engine with the exhaust gasses and the coolant is being employed. With this target, mean values of some parameters (intake and exhaust pressures and temperatures, coolant flow and coolant inlet and outlet temperatures, engine speed and torque) together with instantaneous variables (crankshaft angle, in-cylinder gas pressure, intake and exhaust mass flows) were continuously recorded during the warm-up of the engine. As a result of the work, the dynamics of the thermal balance of the Diesel engine under transient road conditions during the warm-up period was obtained.

In this paper, a methodology for the design process of engine cooling systems is presented, which is based on the interaction among three programs: a code developed for radiator sizing and rating, a 3D commercial code used for the air circuit modeling, and a 1D commercial code used for the modeling and simulation of the complete engine cooling system. The aim of the developed methodology, in addition to ensure the system thermal balance, is the improvement of the design process of the cooling system itself, while shortening the development times, in non-automotive applications. An application to the design of a locomotive engine cooling system is presented. The system designed has been assembled and tested, showing the validity of the methodology, as well as the compliance of the designed system with the initially specified thermo-hydraulic constraints and requirements.

This paper describes the initial works related to the study of Internal Combustion Engines, as an object of mechanical design, at the Universidad Tecnológica de Pereira. It is reported a concise, complete methodology for simple model of internal combustion engine. The emphasis of the paper is placed on the use of the in-cylinder parameters (pressure and temperature) and inertial loads in the crank-slider mechanism to derive the loads that act on all the components of the crank-slider mechanism as well as the theoretical output torque for a given geometrical structure and inertial properties. These loads can then be used to estimate the preliminary dimensions of engine components in the initial stage of engine development. To obtain the pressure and temperature inside the cylinder, under different operation parameters, such as air fuel ratio and spark angle advance, a Zero dimensional model is applied. The heat transfer from the cylinder and friction are not taken into account.