Search Results

The 2013 SRT Viper Carbon Fiber X-Brace, styled by Chrysler's Product Design Office (PDO), is as much of a work of art as it is an engineered structural component. Presented in this paper is the design evolution, development and performance refinement of the composite X-Brace (shown in Figure 1). The single-piece, all Carbon Fiber Reinforced Plastic (CFRP) X-Brace, an important structural component of the body system, was developed from lightweight carbon fiber material to maximize weight reduction and meet performance targets. The development process was driven extensively by virtual engineering, which applied CAE analysis and results to drive the design and improve the design efficiency. Topology optimization and section optimization were used to generate the initial design's shape, form and profile, while respecting the package requirements of the engine compartment.

The development of new materials that are technically and economically viable is no small endeavor. The risks, costs, and time involved in research are usually so high that only governments or private consortia can bear them. And so it has been with the trajectory of carbon fiber reinforced composites, which are capable of providing the lightweighting needed for fuel efficiency, and the mechanical strength required for safety. After a long development cycle, this material is now being widely used by the military, in commercial aircraft, and in the automotive industry. Automotive Carbon Fiber Composites: From Evolution to Implementation, written by Dr. Jackie Rehkopf, senior researcher at Plasan Carbon Composites, gives a high-level summary on carbon reinforced fiber composites specific to the automotive industry in today’s market and its vision for the next 5 to 10 years.

A RIM material was selected for the rear bumper fascia of the Ford GT. As part of its performance criteria, the rear bumper fascia is required to withstand a 1.5 mph corner pendulum impact without sustaining permanent damage. Finite element modeling of this component was undertaken to predict whether the designed bumper fascia would meet the impact criteria. The mechanical properties of the material were required as input to the model, including the yield point and a representation of high strain rate behavior. The paper will present the testing methodology, the determined dynamic yield point, and a material model incorporating strain-rate sensitivity.