Search Results

Stop/Start technology for conventional automatic transmissions has recently received considerable attention in the automotive industry due to the potential fuel economy, and CO2 emission reduction, benefit at minimal cost. Stop/Start was first developed for manual transmission applications in the EU and Japanese markets. When stop/start is applied to any automatic transmission powertrain the powertrain control challenge is to restart the engine in a manner that simultaneously minimizes the delay in transferring torque to the driven wheel(s) and provides a consistently smooth launch feel with low NVH. It has recently been shown that stop/start can be added to a gas engine powertrain with a conventional torque converter automatic transmission while achieving the desired launch characteristics with minimal change to the powertrain hardware and cost.

An engine torque modulation methodology is developed for use in engines equipped with electronic throttle control, ETC. It is shown through simulation that an engine with ETC is capable of following a transmission torque modulation command that includes a linearly increasing torque during the torque phase, a torque reduction during the inertia phase and a post-shift torque increase. It is also shown that such a strategy can be used to minimize the transmission output torque variation during a shift. The impact of engine indicated mean effective pressure, IMEP, variation on vehicle longitudinal acceleration is analyzed using Monte-Carlo simulation. It is shown that the IMEP induced variation in the vehicle acceleration is largely due to end of shift engine torque output timing errors. It is then recommended that during a shift the engine IMEP variation be held to a one-sigma variation of three percent or less.