Search Results

This paper presents the work of the SAE Brake NVH Standards Committee in developing a draft Low-Frequency Brake Noise Test Procedure. The goal of the procedure is to be able to accurately measure noise issues in the frequency range below 900 Hz using a conventional shaft brake noise dynamometer. The tests conducted while evaluating alternative test protocols will be discussed and examined in detail. The unique issues encountered in developing a suitable test procedure for low-frequency noise will be discussed, and the results of tests using both shaft brake dynamometers and chassis dynamometers will be described. The current draft procedure incorporating the knowledge gained from this development effort will be described in detail and conclusions as to its applicability will also be presented

NVH development is an important part of modern brake product development plans. This paper analyzes a typical NVH development process and identifies gaps in available development technologies and processes that when filled can improve the brake NVH development effort. The paper also discusses how the disciplines of simulation, component testing, dynamometer testing, and vehicle testing are currently integrated and proposes more effective processes of development. The paper identifies opportunities for contributions from professional societies and standardization organizations, vendors of test equipment and software, test laboratories, university research centers as well as brake suppliers' engineering centers to improve the engineering toolbox and fill the gaps in brake NVH development.

As part of the development of a new SAE Recommended Practice for brake rotor modal frequencies measurement and control, the SAE Brake NVH Standards Committee developed detailed recommendations for such measurement, data reporting and use in quality control. This paper addresses the need for formalizing measurement techniques of rotor modal frequencies and documenting the proper set up and measurement parameters. Additionally, a rotor mode classification system is proposed so that important rotor modes may be tracked. Statistical control of modal frequencies is presented and practical limits are defined

“Creep groan” is a braking systems noise that is observed when a vehicle is starting to move from a stopped condition with brake pressure applied. Motion takes place when brake pressure is reduced while a motive force, such as an idling engine through an automatic transmission, or gravity due to the vehicle being on a slope, is present. The vibration causing the sound is commonly thought to result from friction force variation in stick-slip mode. Detection and evaluation of “creep groan” noise has been a challenge for NVH test groups. First, this sound typically is not purely tonal like the more common brake squeal, although ultimately it may produce a tonal subjective impression. In this work the authors study different methods that may be applied to “creep groan” detection and evaluation.

Vehicle noise and vibration (NVH) is among the important attributes of the vehicle. This attribute has to be designed for in the product development process. This produces challenges that are usually overlooked by researchers in the field. These challenges are assessed in this manuscript. The emphasis here is on the NVH phenomenon at the vehicle level. Little work is being done to study the vehicle noise and vibration from a system or customer perspective. This manuscript brings to the attention of researchers and the NVH community at large the various NVH challenges that constitute complexities to the development engineer and may deserve closer attention.

Today several international brake acceptance tests exist, like the Los Angeles City Traffic test (LACT) or the Mojacar Noise Route in Spain. During these tests noise evaluation is done subjectively by test drivers, which can cause discrepancies. Sometimes noise data are recorded and evaluated by different, mostly company-specific methods but a procedure that considers the human perception of brake squeal is missing. To fill this gap, the procedure BONI (Brake Objective Noise Index) detailed in this paper is developed based on subjective ratings acquired in hearing tests. It provides reliable prediction of squeal annoyance with high correlation to human perception.

This article, as part III of a series, briefly reviews some of the representative literature on brake squeal testing and evaluation. It discusses the potential influence of variation within brake components and operational conditions on brake squeal dynamometer tests and their correlation to vehicle road tests. Roles and challenges of component/system parameter measurements such as brake pad damping, disc rotor in-plane mode and friction induced vibration characteristics, friction coefficient, moisture absorption and elastic constants of lining material, and contact stiffness are addressed. An application example of a reliability method to assure dynamometer test results are statistically significant is presented. The advantages of using laser metrology are also briefly described, especially the measurement of 3D squeal operational deflection shape. Lastly, general future research directions are outlined.