Search Results

Automotive structural components are exposed to high loads, impact situations and corrosion. In addition, there may be temperature excursions that introduce creep as well as reduced modulus (stiffness). These issues have limited the use of light metals in automotive structural applications primarily to aluminum alloys, and primarily to cast wheels and knuckles (only a few of which are forged), cast brake calipers, and cast control arms. This paper reports on research performed at Chongqing University, Chongqing China, under the auspices of General Motors engineering and directed by the first author, to develop a protocol that uses wrought magnesium in control arms. The goal was to produce a chassis part that could provide the same engineering function as current cast aluminum applications; and since magnesium is 33% less dense than aluminum, would be lighter.

There is an increasing global realization about the need for fuel efficient vehicles. An inexpensive way to accomplish this is through mass reduction, and one of the most effective ways that this can occur is through substituting current materials with magnesium, the lightest structural metal. This document describes the results of a U.S. Automotive Materials Partnership (USAMP) sponsored study [1] that examines why magnesium use has only grown 10% per year and identifies how to promote more widespread commercial applications beyond the 5-6 kg of component currently in vehicles. The issues and concerns which have limited magnesium use are discussed via a series of research and development themes. These address concerns associated with corrosion, fastening, and minimal metalworking/non-traditional casting processing. The automotive and magnesium supplier industries have only a limited ability to develop implementation-ready magnesium components.

This paper describes a new concept for a Ford F-150 light truck Front End Support Assembly (FESA) based on a one-piece die cast structural magnesium component. This new FESA reduces the number of parts and therefore the complexity of manufacturing and assembly, it integrates a multi-piece weldment assembly into a die cast part, and it considerably decreases mass compared to its steel counterpart. The design also reduces FESA cost. Major design criteria included corrosion protection, crashworthiness assessments, Noise Vibration Harshness (NVH) performance, durability and Ford assembly plant constraints. Die casting requirements included feasibility for large volume production, coating strategy and assembly constraints. The resulting design used the flexibility present in a magnesium die-casting that would not be possible using conventional steel stampings and assembly techniques.