Search Results

The regeneration of a loaded particulate filter is one of the biggest challenges in the development of filter systems. The reason is under certain conditions the exhaust gas temperature does not reach the required minimum regeneration temperature for a longer period of time. This paper describes results achieved with a catalytically coated filter alone and in combination with engine parameters, which are used to increase the exhaust gas temperature. The activity of the catalytically coated filter was evaluated by using the well-known balance temperature test. The soot-burning rate was determined at different exhaust gas temperatures. The investigated engine control parameters included intake air throttling and a control of lambda. A special low-temperature transient test was designed to evaluate the regeneration efficiency of the catalytically coated filter and the described engine control parameters under more realistic conditions.

The LEV II and EURO V legislation in 2007/2008 require a high conversion level for nitrogen oxides to meet the emission levels for diesel SUVs and trucks. Therefore, U.S. and European truck manufacturers are considering the introduction of urea SCR systems no later than model year 2005. The current SCR catalysts are based mainly on systems derived from stationary power plant applications. Therefore, improved washcoat based monolith catalysts were developed using standard types of formulations. These catalysts achieved high conversion levels similar to extruded systems in passenger car and truck test cycles. However, to meet further tightening of standards, a new class of catalysts was developed. These advanced type of catalytic coatings proved to be equivalent or even better than standard washcoat formulations. Results will be shown from ESC, MVEG and US-FTP 75 tests to illustrate the progress in catalyst design for urea SCR.

This paper describes the function and application of the preoxidation, hydrolysis and SCR catalysts individually and as a combined system for urea SCR both in model gas and engine bench tests. Using the basic system and a non-optimized urea injection strategy 45% NOx conversion was achieved in the ESC engine test. Adding a preoxidation catalyst significantly improved the NOx conversion in the low temperature region of the engine mapping. NOx conversions over 75% can be achieved in the ESC test using this improved system. With a 50% reduced SCR catalyst volume still a NOx conversion of over 65% could be achieved. Tests after 200 hours engine aging show that the activity of the system is stable.

The following paper highlights the results of a vehicle emission improvement program with emphasis on two main points: In the initial phase, various combinations of Pd and Pt-based three-way catalyst technologies were evaluated on a TLEV and a LEV calibrated vehicle in order to generate ULEV exhaust gas levels. One goal in this portion of the study was to achieve technical equivalence between a viable Pd-based technology and a newly developed Pt-based technology. A combination of the Pd- and Pt-based technologies was able to meet the ULEV and part of the ULEV II regulations in the test vehicle after a catalyst aging cycle that resembles 50,000 miles of vehicle driving. In the later phase, a mathematical algorithm based on the original TLEV and LEV vehicle data was developed in order to conduct computer modeling of the exhaust gas aftertreatment system. This algorithm described the kinetic behavior of the individual catalysts over a broad range of reaction conditions.